R410A电子膨胀阀流量特性的实验研究

来源：叶奇昉 陈江平 陈芝久 　时间：2007年8月17日 11时6分 　发布评论 　进入论坛

参考文献
    [1] Stabler LA. Theory and use of a capillary tube for liquid refrigerantcontrol. Refrigerating Eng 1948;55(1):55–9.
    [2] Li RY, Lin S, Chen ZH. Numerical modeling of thermodynamic non-equilibriumflow of refrigerant through capillary tubes. ASHRAE Trans 1990;96(1):542–9.
    [3] Chen ZH, Li RY, Lin S, Chen ZY. A correlation for metastableflow of refrigerant 12 through capillary tubes.ASHRAE Trans 1990;96(1):550–4
    [4] Wijaya H. Adiabatic capillary tube test data for HFC-134a. In: Proceedings of the Int. Refrigeration Conf. At Purdue, West Lafayette, Indiana, USA; 1992. p. 63–71.
    [5] Wolf DA, Bittle RR, Pate MB. Adiabatic capillary tube performancewith alternative refrigerants. ASHRAE RP-762, 1995.
    [6]Melo C, Ferreira RTS, Neto CB, Goncalves JM, Mezavila MM. Anexperimental analysis of adiabatic capillary tubes. Applied Thermal Eng1999;19:669–94.
    [7]Kim SG, Kim MS, Ro ST. Experimental investigation of theperformance of R22, R407C, and R410A in several capillary tubes for air-conditioner. Int J Refrigeration 2002;25:521–31.
    [8]Aaron DA, Domanski PA.Experimentation, analysis, and correlation of refrigerant-22 flow through shorttube restrictors. ASHRAE Trans 1990;96(1):729–42.
    [9]Kim YC, O’Neal DL. Two-phaseflow of R-22 through short tube orifices. ASHRAE Trans 1994;100(1):323–34.
    [10]Choi Chung,Kim. A generalized correlation fortwo-phase flow of alternative refrigerants through short tube orifices. International Journal ofRefrigeration 27 (2004) 393–400
    [11]Yongchan Kim, 1994. “Two-phase Flow of R-134a and R-12 through Short-Tube Orifices”, ASHRAE Transactions 100(part2), 582-591.
    [12] Kim Y, O’Neal DL. Asemi-empirical model of two-phase flow of refrigerant-134-a through short tubeorifices.Experimental Thermal and Fluid Science 1994;9(4):426–35.
    [13] Singh GM, Hrnjak PS, Bullard CW.Semi-empirical model of refrigerant R134a flow through orifice tubes. International Journal of HVAC&R Research 2001;7(3):245–62.
    [14] 市川常雄, 清水孝,ボペット牟の流量系にっぃて，机论31卷222号1965,PP.317-319.
    [15] 笠井浩爾, 丹ボすぺト弁の流量系数につぃて, 机论32卷, 251号,1967:1083-1096.
    [16] stone J A. Discharge coefficientand steady—state flow forces for hydraulic poppet valves. Trans ASME,Jour.Engng,82 Ser.D-1(march 1960):144-158.
    [17] 阿武芳朗 秋山伸幸, スぅ-ル形油压方向切换牟の流量系数にっぃて(第一报,第二报).日本机械学会论文集36卷286号1970, PP.960-981.
    [18] Wile D.D. “The Measurement ofExpansion Valve Capacity”, Refrigeration Engineering,1935(8).
    [19]DaviesA Davids T C “Single and Two-phase Flow of DIchlorodifluoromethrane throughSharp-edaged Orifices”,ASHRAE Transaction 1973,79,part

    相关文章：热力膨胀阀介绍
              膨胀阀对陈列柜温度的影响
              电子膨胀阀动态特性的辨识
              热力膨胀阀的正确选配方法

标题;


验证码：

• ·电动机智能节能控制器的研究
• ·商业大楼中央空调系统设备节能方案

• ·空调温控器系列
• ·制冷剂R22
• ·风柜空调
• ·阿法拉伐板式换热器
• ·格力家用中央空调
• ·制冷工程